In Zakeke you have pre-loaded fonts, but you can upload your own fonts as well.
Uploading your own fonts
Before you start
You may need to change the name of your font. This must be done from the font metadata, not just renaming the font file. You can do it by using a tool like this.
How to add your own fonts
In your Zakeke back-office, go to the Fonts > Add New Fonts
- TTF (TrueType)
- OTF (OpenType)
You can upload all fonts at once in a ZIP package.
Please note that the installation of new fonts may require a few minutes. After uploading the files, you will be taken to the "Fonts" page in the "in processing" section where you can check the status of the installation. Possible statutes are as follows:
Waiting - Your fonts have not yet been processed.
Processing - Fonts are being processed and will be installed.
Error - One or more fonts have not been processed. Hover over the element to read the last error.
Completed - Fonts have been successfully processed.
WARNING: When a font load is in the
Completed state, it may take a few seconds for the font to be fully usable.
How to set available fonts for a printing method
Once fonts have been installed, they're available for all products and printing methods. However, you may want to limit the available fonts for a specific printing method. If so, do as follows:
Go to Printing Methods.
Choose or add a printing method.
In the section Fonts, you can select one or more fonts to associate with the printing method and the default font (it will be the default font when the customizer initializes).
Instead, if you check All Fonts it will associate all fonts available in your Fonts section to the printing method.